Images
|
| Light Duty All Gear |
165 gear head
TECHNICAL DATA AND SPECIFICATIONS |
|
STD C.H. |
Centre Height over flat bed ways : |
165 m.m. |
Swing Over Bed : |
320 m.m. |
Swing Over Cross Slide : |
180 m.m. |
Swing In Gap : |
510 m.m. |
Motor |
2 hp |
|
|
MODEL |
ADMIT
BETWEEN
CENTRES |
LENGTH
OF BED |
Floor Space
Occupied (m.m.) |
Aprox. Weight
in kgs. |
Aprox. Case
Dimensions
(m.m.) |
Nett. |
Gross |
AHD-1 |
520 m.m. |
1675 m.m. (4’-6”) |
1400x900 |
550 |
675 |
1600x700x1330 |
| |
|
|
|
|
|
|
|
|
Spindle bore
Spindle Adapter Morse Taper
Spindle Speeds Nos. / RPM Range
Spindle Mounting on |
: 38 m.m.
: MT - 3
: 8 /48-1000
Taper Roller Bearings
|
|
TAIL STOCK SPINDLE : |
Spindle Diameter :
Spindle Travel :
Spindle Morse Taper :
|
38 m.m.
145 m.m.
MT - 3
|
LEADING SCREW : THREADS |
Nos. of Threads / Range |
Metric : |
17 / 0.5 m.m. To 15 m.m. Pitch |
| (For Fully norton Gearbox) |
Inch : |
40 / 2 to 60 TPI |
|
ELECTRICALS : |
Electirc motor of 2 HP / 1.5 k.w., 3 Phase, 1440 RPM with Panel board wirings, over load relay, Pushbutton switches, V-belts and fittings. |
STANDARD ACCESSORIES :
Flame Hardened bed ways, Chuck back plate 1 no, centre adapter, Dead centres 2 nos., Tool Post Spanner, Motor pulley, Thread dial indicator, Change gear set - 1 (For metric and inch both) and Norton gearbox.
OPTIONAL ACCESSORIES :
Face plate, Carrier plate, steady rest, follow rest, Taper turning attachment, motorised coolant pump with tank and fittings, Rear tool post with extended cross slide, Chuck back plates (Extra), and Electricals (Motor, Panel board, Wirings, Push button Switches, V-belts and fittings), Electrical Switch shaft and chip guard.
|
NOTE : |
(1) As improvements are constantly made in our machines, the above illustrations, specifications, dimensions and technical data are subject to modifications and change without prior notice and not binding on us.
(2) The descriptions of standard accessories confirms to it's list and not the photograph of the machine shown in the catalogue.
|
|
EXTRA ACCESSORIES :
Face plate, Carrier plate, steady rest, follow rest, Taper turning attachment, ortoned coolant pump with tank and fittings, Rear tool post with extended cross slide, Chuck back plates (Extra), and Electricals (Motor, Panel board, Wirings, Push button Switches, V-belts and fittings), Electrical Switch shaft and chip guard.
|
|
|
|
|
